Installation Instructions

3
ASSEMBLY INSTRUCTIONS (continued) ASSEMBLY INSTRUCTIONS
6
14. Once connections of wires are completed,
carefully tuck wires and wire nuts (AA) into the
electrical box making sure no bare wire
(on the black and white) is visible at the
wire nuts (AA).
DD
15. Slide the canopy (DD) up the chain (EE)
and over the upper connector. Slide the nut
up the chain (EE) and thread onto the upper
connector.
Nut
16. Install specified bulb type and wattage
(not included).
17. Remove the 2 cable ties tightened in Step 4.
1. Remove the fixture (A) from the box. Use
the small box to hold the fixture (A). Spread
the rings evenly.
Box
Top Circle
2. Install 2pcs of “A1” to the fixture (A) by
tightening the screws.
Box
A
A
Box
A
3. Position the tab to the hole on the ring.
Screw
4. Use the cable tie (FF) supplied to hold the
2 joints temporarily for easy installation.
Box
FF
Bulb
A1
A1
A1A1