Installation Instructions

5
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS (continued)
4
11. To attach chain loop to light fixture, use
a screwdriver and wrench to open and
close chain loop. Ensure to close the
opening. Weave the power cord and
ground wire through the links in the chain
(EE).
Power
Cord
C
13. Connect the ground wires (bare copper
or green) from your fixture to the ground
wire (bare copper or green) or ground
screw in the electrical box. Connect the
black wire (or wire marked “SPT-1”) from
the fixture to the black wire in the electrical
box and connect the white wire (or the wire
with ribbed side) from the fixture to the
white wire in the electrical box.
Black
House supply
Ground wire
Fixture
Ground
wire
AA
AA
White
Electrical
Box
9. Determine the height that you would
like to hang your fixture. Trim the cord and
chain. Allow 10” of extra wiring for the
electrical box connections.
CC
BB
BB
EE
EE
DD
10. Loosen the upper connector from
nipple. Attach the mounting bracket (BB)
to the electrical box using electrical box
screws (CC). Attach the nipple to the
mounting bracket (BB) and adjust until it will
clear the canopy (DD) when assembled
(Place the canopy (DD) over the nipple
and tighten the upper connector onto
the nipple until snug. The upper connector
should hold the canopy (DD) snug to the
ceiling). Lock the nipple in the correct
position using the hex nut.
12. Loosen the nut on the upper connector
and slide it down the chain (EE) towards the
lower connector. Slide the canopy (DD) down
the chain (EE) towards the lower connector.
Feed the wire through nut, canopy (DD), the
upper connector and onto the nipple.
Tighten the upper connector onto the nipple.
Spread the other end of the chain (EE) open
and fasten to the upper connector. Ensure
the opening is closed.
Nipple
Nipple
Nipple
Upper connector
Upper connector
Hex nut
Nut
C
B
B
A
5. Remove the loop (C), top cover and small
tube from fixture body (B). Screw the center
rod to the fixture body (B).
Top Cover
Small Tube
Center Rod
6. Route the cord through the top circle.
Place the small tube and top cover in place.
Slightly slide the fixture body (B) into the
fixture (A). Install the fixture body (B) to the
fixture (A) by tightening the loop (C) against
the top cover.
Box
C
Top CoverSmall
Tube
7. Install 4pcs of “A2” in place by tightening
the screws.
Box
8. Install the side cover (HH) by tightening
the finial (II) against the screw stem (GG).
GG
HH
II
A2
A2
A2
A2