Installation Instructions

ManualsBrandsPatriot Lighting ManualsIndoor LightingEvan Matte Black and Brushed Nickel 5-Light Pendant Light

Sku Number: 351-9176

5LT Chandelier

Model Number: ICH282B05BKN25-M

Questions, problems, missing parts?

Before returning to your retailer, call our customer service

at 1-800-267-4427 Monday – Friday 8:00 a.m. – 5:00 p.m. EST

PACKAGE CONTENTS

HARDWARE CONTENTS Note: Hardware not shown actual size.

12-19

Wire Nut

x 3

Electrical Box Screw

x 2

Canopy

x 1

Chain

x 1

Mounting Bracket

x 1

Cable Tie

x 2

Finial

x 2

Side Cover

x 2

Screw Stem

x 2

Summary of content (4 pages)

PAGE 1
Sku Number: 351-9176 5LT Chandelier Model Number: ICH282B05BKN25-M Questions, problems, missing parts? Before returning to your retailer, call our customer service at 1-800-267-4427 Monday – Friday 8:00 a.m. – 5:00 p.m. EST PACKAGE CONTENTS A2 A2 C A A1 B HARDWARE CONTENTS Note: Hardware not shown actual size.
PAGE 2
7 IMPORTANT SAFETY INSTRUCTIONS CARE AND MAINTENANCE Please read and understand this entire manual before attempting to assemble, operate or install the product. • To clean, turn off and wipe with a damp, non-abrasive cloth. Please save this instruction manual. • When cleaning, use only a soft brush or lint free cloth to avoid scratching the finish. WARNING • Abrasive cleaning agents are not required and should be avoided to prevent damage to the finish.
PAGE 3
4 5 ASSEMBLY INSTRUCTIONS (continued) ASSEMBLY INSTRUCTIONS 5. Remove the loop (C), top cover and small tube from fixture body (B). Screw the center rod to the fixture body (B). 9. Determine the height that you would like to hang your fixture. Trim the cord and chain. Allow 10” of extra wiring for the electrical box connections. 7. Install 4pcs of “A2” in place by tightening the screws. C BB Top Cover Nipple Small Tube Upper connector A2 A2 Center Rod B A2 A2 Box 6.
PAGE 4
6 3 ASSEMBLY INSTRUCTIONS (continued) ASSEMBLY INSTRUCTIONS 14. Once connections of wires are completed, carefully tuck wires and wire nuts (AA) into the electrical box making sure no bare wire (on the black and white) is visible at the wire nuts (AA). 1. Remove the fixture (A) from the box. Use the small box to hold the fixture (A). Spread the rings evenly. 3. Position the tab to the hole on the ring. A1 Top Circle 15. Slide the canopy (DD) up the chain (EE) and over the upper connector.