Installation Instructions
Page 3 of 4
190617
Spare Parts List:
The following parts are available for re-order if damaged or missing. Call our toll free at 1-800-887-6326
Turn on the power at fuse or
circuit box
5. Pull out the source wires from
the outlet box. Make wire
connections using wire
connectors (CC) as follows:
---Connect the hot wire ( black
insulation) from the fixture to
the black wire from the power
source.
---Connect the neutral wire
(white insulation) from the
fixture to the white wire from
the power source.
---Attach the fixture ground wire ( bare wire) to the
mounting strap unit (AA) with the green ground screw,
then connect it to the house ground wire with the wire
connector (CC).
Carefully put all of the wires back into the outlet box.
Assembly Kit
6122MM (1 SET)
4. Place the canopy (A) onto the
swivels (B), secure them with
two washers (EE), two butterfly
nuts (FF) and ground wire
(GG).
6. Secure the canopy (A) to the
mounting plate unit (AA) by
inserting the fixture mounting
screws, then secure it with two
ball nuts (DD) .
7. Attach the outer glass shade
(H) onto the glass holder and
put the stand in, then tighten the
inner glass shade (G) with the
socket ring and supplied socket
fixer (HH).
Install 5 X 60W medium base
bulbs (not included).
See relamping label at socket
area or packaging for maximum
allowed wattage.
5
CC
AA
Green Ground
Screw
Outlet Box
4
FF
GG
B
A
EE
6
AA
A
DD
Medium Base Bulb 60W
(not included)
7
Glass Holder
Stand
Socket Ring
HH
G
H
6”Rod
3206RD
12”Rod
3207RD
Outer Glass Shade
10098CE
Inner Glass Shade
10097EW
Mounting plate Unit
X1
Ball Nut
X2
Mounting Screw
X2
Wire Connector
X3
AA BB CC DD
Washer
X2
Socket Fixer
X1
Butterfly Nut
X2
Ground Wire
X1
EE FF GG HH
Fixture Mounting Screw