Installation Instructions
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
Page 2 of 4
190617
ASSEMBLY INSTRUCTIONS
PREPARATION
Turn off the power at fuse or circuit box
2. --- Rod connections:
a. Thread the fixture wire from
the fixture through one of
the 12" rods (F) ,then
secure the 2 x 12" rods (F)
onto the fixture.
b. Thread the fixture wire
through one of the 35mm
threaded pipe-1, then twist
the 2 x 35mm thread pipe-1
into the 2x12" rods (F).
c. Put the curving rod (E) on
the 2 x 35mm threaded
pipe-1, then thread the fixture wire through one of the
rods (D) and secure the curving rod (E) with the rods (D).
d. Thread the fixture wire through one of the rods (C),
then secure the rods (C) with the threaded pipe.
Note: The height can be adjustable from 17" to 55-1/2"
by using the rods. Use fewer rods if shorter height is
desired.
1. Secure mounting plate unit (AA)
to the outlet box using two
mounting screws (BB).
Adjust the length of fixture
mounting screws on the
mounting plate unit (AA) if
necessary.
3.
Thread the fixture wires through
the fixture canopy and
insert
threaded pipe-a
of coupling kits
into the outer holes of fixture
canopy (A).
3
Threaded
Pipe
Coupling Kit
Threaded
Pipe-a
A
Outlet Box
1
AA
BB
Fixture Mounting
Screw
2
Threaded Pipe
Threaded Pipe
Socket
Threaded Pipe-1
(35mm)
D
Threaded Pipe
C
F
E