Installation Instructions

Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
Page 2 of 3
SAFETY INFORMATION
190614
BB
AA
ASSEMBLY INSTRUCTIONS
PREPARATION
Turn off the power at fuse or circuit box.
1. Secure the mounting strap unit (AA)
to outlet box with mounting screws
(BB).
Note: The depth of threaded pipe
on the mounting strap unit may
need to be adjusted to properly
fit the canopy.
2. Secure the loop (A) on the fixture.
1
1
3. - Determine length of chain (FF)
needed to achieve desired fixture
height. (To remove excess chain
section, use pliers to bend link
open.)
- Weave the fixture wires and
fixture ground wire through the
chain (FF), the collar (EE) and
the canopy (DD).
- Connect the chain(FF) to the
loop (A) and the top loop on the
mounting strap unit (AA) using
the two loop locks (GG).
- Thread the fixture wires and
fixture ground wire through the center of the
mounting strap unit (AA).
EE
GG
GG
FF
A
DD
AA
3
AA
DD
CC
4
2
4. Connect the smooth wire from the
fixture to black wire from the outlet
box (power), the ribbed wire from
the fixture to white wire from the
outlet box (neutral) with the wire
connectors (CC) provided.
Connect the copper wire on the
light fixture to the mounting strap
unit (AA) by securing it with the preinstalled ground
screw, then connect it to the house ground wire with
wire connectors (CC).
Tuck all the wires into outlet box.
Fixture
A