Installation Instructions

Question/Comment/Missing Part?

Customer Service 1-800-205-6201

WARNI NG:

TO AVOID RISK OF ELECTRICAL SHOCK

TURN OFF OR DISCONNECT FROM POWER

WHILE INSTALLING OR SERVICING UNIT

Installation Instructions: 351-0013 (M-FP-7R-W) | 7.5" 1000 Lumen LED Round Flat Panel Light

TROUBLE SHOOTING

Problem Possible Cause Solution

The xture does not light The power is off Check that the power supply is ON.

There is a bad wire connection. Check the wiring

The switch is defective Test or replace the switch

Circuit breaker trips when power is

sent to the light.

Incorrect wire connections, or hot

wires are grounding out.

Ensure wires are connected

correctly.

INSTALLATION INSTRUCTIONS (For Junction Box)

1. If you want to install one of the provided trims;

place the trim over the front face of the LED light

and bend the clips around the back to latch it in

place.

2. Safety Concern! Always turn off the power at the

breaker when installing light xtures.

3. Disconnect the male E26 adapter (DD), Grounding

Wire and Screw (FF, II), and the Mounting Bracket

(BB).

4. Locate each wire: hot (black), Neutral (white)

and ground (green or bare copper) on the

connection wire (EE). Connect these wires to

their corresponding junction box wires using the

provided wire nuts (HH). Refer to Fig 1. Be sure

to attach the grounding wire (FF) to the mounting

plate (BB) with the grounding screw (II).

5. Before installing, use the Color Temperature

Guide Card select whichever color temperature

best ts your environment with the selector on

the back of the light.

6. Screw the mounting bracket (BB) into the junction

box with the provided screws (GG). Refer to Fig 2.

7. Press the LED light into the mounting bracket,

making sure that the clips engage and are secure.

Refer to Fig 3.

1. 2.

Fig. 1