Installation Instructions

Question/Comment/Missing Part?
Customer Service 1-800-205-6201
WARNI NG:
TO AVOID RISK OF ELECTRICAL SHOCK
TURN OFF OR DISCONNECT FROM POWER
WHILE INSTALLING OR SERVICING UNIT
Installation Instructions: 351-0001 (M-FP-11R-W) | 11" 1700 Lumen LED Round Flat Panel Light
1. If you want to install one of the provided trims;
place the trim over the front face of the LED
light and bend the clips around the back to
latch it in place.
2. Before starting any installation, be sure to
verify that the power is OFF at the circuit
breaker. Locate each wire: hot (black), Neutral
(white) and ground (green or bare copper,).
3. Remove the mounting ring from the LED Light.
4. Using the provided screws, secure the
mounting ring to the junction box (refer to
gure 1). If you are installing this xtures
using drywall anchors, proceed with the
remaining sub-steps of step 3. If not, proceed
to the next step.
• Mark the ceiling where the two anchors
will be set. Refer to gure 2.
• Remove the mounting ring, and drill holes
with a 5/16” drill bit, then place the plastic
anchors.
• Use the provided screws to set the
mounting ring on the junction box, then
fasten the mounting ring to the plastic
anchors.
5. Attach the safety wire to the LED Light refer
to gure 3. Then connect each wire to its
corresponding color. Black to black, white to
white, and ground to ground (this is either
green or bare copper.) Refer to Fig. D.
6. Now lift the LED Light into position and
match the openings on the Back Plate to
the mounting ring’s feet. Once in place twist
the xture clockwise so that it locks into the
mounting ring. Refer to gure 4.
7. Once secure, re-activate the power from the
circuit breaker. If the light does not illuminate,
refer to the trouble shooting section on the
following page.
8. Using the color temperature card provided,
select what color temperature best suits your
environment.
INSTALLATION INSTRUCTIONS