Installation Instructions

ManualsBrandsPatriot Lighting ManualsFlush Mount LightsLegend Bronze LED Flush Mount Ceiling Light

Model #: FL1128-BR4-19LF0-T

FL1128-NK7-19LF0-T

Legend Flush Mount

Hardware kit*

*Actual hardware may differ from illustration

Required

Decorative Cap

Threaded Tube

Hex Nut

Lock Washer

Hex Nut

Fixture Pan

Diffuser

Item #: 351-9140

351-9141

Need Help?

Questions? Call our Customer Service Center 1-800-291-8838.

Shut off power at the circuit breaker or fuse panel before removing the old fixture or installing the new one.

LEDs can be damaged by electrostatic discharge shock. Before installation, discharge yourself by touching a grounded bare metal surface to remove

this hazard.

For INDOOR use only. For electrical requirements, see fixture. Minimum 90° C supply conductors.

THIS FIXTURE IS DIMMABLE BY SPECIFIC FORWARD PHASE ELECTRONIC (TRAIC) DIMMERS AND IS NOT COMPATIBLE WITH 0-10V DIMMING

SYSTEMS. Dimmers tested to be compatible with this fixture are the Lutron: Diva

C•L

™

: DVWCL-153P or DVCL-153P, Lumea

C•L

™

: LGCL-153P, and

Toggler

C•L

™

: TGCL-153P. (This list of dimmers does not imply any guarantee or warranty of compatibility with a particular application. Dimmers not

listed do not imply non-compatibility.)

If unsure if the electrical box is properly grounded, or the box is plastic and has no ground wire, or are unfamiliar with the methods of properly

grounding fixture, consult a qualified electrician.

Do NOT use solvents or cleaners containing abrasive agents. Do not spray liquid cleaner directly onto the LEDs, fixture, diffuser, or wiring.

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning:

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the

equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment gener-

ates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the

equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or

an experienced radio/TV technician for help.

Warnings and Cautions

Patriot Lighting

Warranty

FIVE-YEAR LIMITED WARRANTY: If, during normal use, this PATRIOT LIGHTING

lighting fixture breaks or fails due to a defect in material and

workmanship within five (5) years from the date of original purchase, simply bring this lighting fixture with the original sales receipt back to your nearest

MENARDS

retail store. At its discretion, PATRIOT LIGHTING

agrees to have the product or any defective part(s) repaired or replaced with the same or

similar PATRIOT LIGHTING

product or part free of charge, within the stated warranty period, when returned by the original purchaser with the original

sales receipt. This warranty; (1) excludes expendable parts including but not limited to light bulbs; (2) does not cover damage that has resulted from abuse

or misuse; and (3) does not cover any losses, labor, injuries to persons/property or costs. This warranty does give you specific legal rights and you may

have other rights, which vary from state to state.

Summary of content (2 pages)

PAGE 1
Item #: 351-9140 351-9141 Legend Flush Mount Model #: FL1128-BR4-19LF0-T FL1128-NK7-19LF0-T Hardware kit* Hex Nut AA x2 Lock Washer BB x1 Fixture Pan Threaded Tube Hex Nut CC x2 DD x1 FF x1 EE x3 GG x1 *Actual hardware may differ from illustration Required Decorative Cap Diffuser Hex Nut Need Help? Questions? Call our Customer Service Center 1-800-291-8838. Warnings and Cautions Shut off power at the circuit breaker or fuse panel before removing the old fixture or installing the new one.
PAGE 2
1 2 AA x2 BB x1 3/4 in. 19 mm DD CC CC x2 BB CC DD x1 1 Attach fixture mounting screws (AA) into electrical box and leave extended about 3/4 in. below the ceiling line. 2 Attach the threaded tube (BB) to the center hole in the pan using the hex nuts (CC) and lock washer (DD). Ensure 3/8 inches to 1/2 inch of the threaded tube is protruding on the back surface of the pan in order to allow enough space for the diffuser, cap, and finial to be attached.