Installation Instructions

ManualsBrandsPatriot Lighting ManualsFlush Mount LightsEdrick Chrome Integrated LED Flush Mount Ceiling Light

SKU Number: 351-8420

Edrick 4-Lt Track Light

Model Number: EDKF3018L30D1PC

HARDWARE CONTENTS Note: Hardware shown not actual size.

Gem Bar

Junction Box

Screws

Wire Nuts

PACKAGE CONTENTS

Questions, problems, missing parts?

Before returning to your retailer, call our customer service at 1-800-873-2326

Monday - Friday, 8:00 am-4:30 pm Central Standard Time

Flathead Screw

Summary of content (4 pages)

PAGE 1
SKU Number: 351-8420 Edrick 4-Lt Track Light Model Number: EDKF3018L30D1PC Questions, problems, missing parts? Before returning to your retailer, call our customer service at 1-800-873-2326 Monday - Friday, 8:00 am-4:30 pm Central Standard Time PACKAGE CONTENTS A HARDWARE CONTENTS AA Note: Hardware shown not actual size.
PAGE 2
SAFETY INFORMATION Read all safety precautions and installation instructions carefully before installing or servicing this fixture. Failure to comply with these instructions could result in potentially fatal electric shock and/or property damage. It is recommended that a qualified electrician perform all wiring. This fixture must be wired in accordance with all national and local electrical codes.
PAGE 3
ASSEMBLY INSTRUCTIONS 1. Separate the gem bar (AA) from the fixture canopy (A) by removing two canopy screws (DD). 1 AA DD A 2. Mount gem bar (AA) to the junction box (not included) using two screws (BB) to secure it. 2 Wiring – all wiring must take place inside junction box. Caution: Make sure power is off at fuse or circuit breaker box. Check power wires for damage or scrapes. If power supply wires are within three inches of the LED driver, use wire suitable for at least 90°C (194°F).
PAGE 4
CARE AND MAINTENANCE Use a dry or slightly damp clean cloth to wipe the surface of the fixture. Do not use any cleaner with chemical solutions and abrasive pad. If necessary, use a mild soap with water to clean off any dirt or stains. TROUBLESHOOTING 1. The light does not come on at all: a) Make sure the wall switch and circuit breaker are turned on b) Make sure all wiring connections are connected and secured. 2.