Installation Instructions

3
Turn off circuit breakers and wall switch to the fixture
supply line leads.
WARNING: Failure to disconnect power supply prior to
installation may result in serious injury.
ON
OFF
ON
OFF
ASSEMBLY INSTRUCTIONS
Unscrew decorative nuts (CC) and remove mounting plate (AA)
from fixture. Save decorative nuts for later use.
NOTE: Do not remove screws (BB) or nuts (DD) from mounting
plate (AA).
2.
3.
Remove existing fixture.
WARNING: When using an existing outlet box, be sure the outlet box
is securely attached to the building structure and can support the full
weight of the fixture. Failure to do so can result in serious injury.
1.
CC
CC
BB
DD
AA
5.
Attach mounting plate (AA) to outlet box (not included) using
the existing screws and washers or the mounting screws (FF)
provided in hardware pack.
Tip: Seek the help of another person to lift the fixture up to
you once you are set on the ladder.
Outlet Box
Outlet Box
Screws and
Washers
AA
4.
If you wish, adjust cord length to desired hanging length by
loosening the cord restraint. Pull cord through canopy (A) until
at proper length, and then re-tighten cord restraint in order to
hold cord at desired length. Repeat for other cords you wish to
adjust. Do not overtighten cord restraints.
CAUTION: Carefully arrange excess cords within canopy,
making sure they will NOT be underneath the mounting plate
(AA) when attaching the fixture in Step 8.
Cord
Restraint
A