Installation Instructions

House Grounding Wire
Outlet Box
Wire Nut
Mounting Strap
Green Grounding Screw
Mounting Screw
Screw
Fixture Grounding Wire
Fig.1
Screw
Key Hole Slot
Metal Pad
Glass Shade
Finial
Cap
Hex Nut
Pan
Socket
Coupling
Washer
Hex Nut
Threaded Pipe
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
WARNING: BE SURE TO SHUT OFF POWER AT THE MAIN FUSE OR CIRCUIT
BREAKER BOX BEFORE INSTALLING OR SERVICING THIS FIXTURE.
NOTE: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. Customer Service: 1-800-887-6326 (weekdays 9 a.m. – 5 p.m. CST)
3. READ AND SAVE THESE INSTRUCTIONS.
350-4834
100427
1. Attach two screws to the holes on the mounting strap, and screw in 2 to 3 turns.
2. Attach the mounting strap to the outlet box using two mounting screws.
3. Pull out the outlet wires and the house grounding wire from the outlet box. Make wire connections
using the wire nuts:
---The black wire from the fixture to the black wire from the power source.
---The white wire from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw. Then
connect it to the house grounding wire with the wire nut.
Carefully put the wires back into the outlet box.
4. Attach the pan to the mounting strap by inserting two screw heads into the key holes, and rotate the
pan until it locks in place. Then secure the screws tightly. (See Fig.1)
5. Screw the threaded pipe into the coupling, then secure it with a washer and hex nut.
6. Install bulbs (not included). See relamping label at socket area or packaging for maximum allowed
wattage.
7. Attach the glass shade to the pan by inserting the threaded pipe, then secure it with a metal pad and
hex nut. Then carefully attach the cap to the glass shade and secure it with the finial.
8. Turn on the power at the main fuse or circuit breaker box.
Bulb Type A Max.60W
(not included)