Installation Instructions

USER GUIDE (continued)
The app supports three configurations: Add Manually mode, Auto scan search device mode and AP mode.
1. Click add device or upper
right corner and enter the
next page shown in Fig. 2.
2. Click lighting to enter the
next page shown in Fig. 3.
1
My Home
3. Click lighting (BLE +WiFi) to
enter the next page shown in
Fig.4.
5. To select “Add Manually Mode", please make sure the indicator light on the smart device is flashing rapidly (blinking
twice per second) and then click the button to proceed to the next step. If the indicator light is not flashing rapidly
(can be switched by on-off-on-off-on-wall switch) as shown in Fig.5, Fig.5a, Fig.5b, Fig.5c. Click next to enter the
next page shown in Fig.6.
Note: Switch the device on, off, on, off, and on (subject to the user manual)
How to set indicator light to rapid flashing.
3
4. Click NEXT to enter the
page below.
4
5 5a 5b 5c
2
Page 7 of 34
210623
Add Manually
Click “Add Device" or "+" at the top right corner of the App homepage to enter the “Add Device" page.