Installation Instructions

Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder.
Only general ON/OFF wall switch applies for this fixture, the dimmable wall switch shouldn’t be required.
If you are unfamiliar with electrical installation, it is recommended to use a qualified electrician for your installation(s).
Mobile device requirements：Iphone 4S or newer running IOS 9.0 x or later. Android v5.0 or later.
SAFETY INFORMATION
PREPARATION
ASSEMBLY INSTRUCTIONS
Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
• Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching
off circuit breaker).
• Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
• LED electronics can be damaged by electro static discharge (ESD)shock. Before installation, discharge yourself
by touching a grounded bare metal surface to remove this hazard. To avoid damage, do not touch the LED module.
CAUTION
• All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
• Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
• Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
Turn off the power at fuse or circuit box.
Turn on the power at fuse or circuit
box.
1. Attach the two mounting screws
(AA) to the holes on outlet box,
thread them in part way: 2 to 3
turns only.
2. Connect the black to black (power),
white to white (neutral) and copper
wire or green / yellow wire to
ground wire with supplied wire
connectors (BB).
Tuck all wires into outlet box.
AA
1
1
1
2
BB
4. Attach the plastic shade (B) to the
ceiling pan (A) by aligning studs
and slots, then turn it clockwise
until it is locked in place.
Stud
A
4
Slot
B
3. Attach the ceiling pan (A) to the
outlet box by inserting two
mounting screws (AA) head into
the key holes, then rotate the
ceiling pan until it is locked in
place, finally secure the mounting
screws tightly with screwdriver (not
included).
A
3
AA
Page 2 of 34
210623