Installation Instructions

USER GUIDE (continued)
7. To select “AP Mode", please make sure the
indicator light on the smart device is flashing slowly
(blinking once every three seconds) and then click
the button to proceed to the next step.
If the indicator light is not flashing slowly (can be
switched by on-off-on-off-on-wall switch), as shown
in Fig.7, Fig.7a, Fig.7b, Fig.7c and Fig7d.
Click next to enter the next page shown in Fig.8.
Note: Switch the device on, off, on, off, and on
(subject to the user manual) How to set
indicator light to slow flashing.
AP Mode Devices
7
8. Make sure the light flashes
every 3 seconds, after
checking, enter the next page
shown in Fig.9.
8
9. Click next to enter the
next page shown in Fig.10.
9
7a
7b
7c
7d
Page 13 of 34
210623