Installation Instructions

ManualsBrandsPatriot Lighting ManualsFlush Mount LightsJulius Integrated LED Flush Mount Ceiling Light

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install the product.

WARNING

● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or

switching off circuit breaker).

● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact

any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury

or death from electric shock.

● LED electronics can be damaged by electro static discharge (ESD)shock. Before installation, discharge yourself

by touching a grounded bare metal surface to remove this hazard. To avoid damage, do not touch the LED module.

CAUTION

● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).

Contact your municipal building department to learn about your local codes, permits and/or inspections.

● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician

before installation.

● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use

a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,

do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper

grounding methods as required by the local electrical code in your area.

● If a dimmer control switch is used with this fixture, obtain professional advice to determine the correct type and

electrical rating required.

PREPARATION

Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with

package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,

install or operate the product. Contact customer service for replacement parts.

Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Electrical Tape, Wire Cutters, Safety

Glasses, Ladder, Wire Stripper.

Turn on the power at fuse or circuit

box.

Page 2 of 4

190829

ASSEMBLY INSTRUCTIONS

Turn off the power at fuse or circuit box.

1. Attach the two mounting screws

(AA) to the holes on outlet box,

thread them in part way: 2 to 3

turns only.

2. Connect the black to black (power),

white to white (neutral) and copper

wire or green / yellow wire to

ground wire with supplied wire

connectors (BB).

Tuck all wires into outlet box.

3. Attach the ceiling pan (A) to the

outlet box by inserting two

mounting screws (AA) head into

the key holes, then rotate the

ceiling pan until it is locked in place,

finally secure the mounting screws

tightly with screwdriver (not

included).

4. Rotate the frosted white acrylic

shade (B) to the ceiling pan (A)

until it is locked in place.