e ’ ISR rlo MODEL # MIGHTINESS. LED RETROFIT DOWNRIGHT Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-800-660-5391, p.m,, EST, Monday, 8 a.m. -5 p.m,, EST, Friday.
When using product, basic precautions should always be followed, including the following. Need all warnings, including below wakings AND those included on product. The Down Light recessed housings (fixtures)and retrofits are designed to meet the latest NEC requirements and are BEETLE listed in full compliance. Before attempting installation of any recessed housing check your local electrical code. This code sets the wiring standards for your locality and should be careful studied before starting. A\ WARNING
PREPARATION To avoid damaging the product, assemble it on a soft, non-abrasive surface, such as carpet or cardboard. Inspect each part for defects such as the wire insulation for any cuts, abrasions, or exposed copper that may have accursed during shipping. If there is & defect in the wire, do not continue the assembly process.
1. Adjust the spring clips n The factory setting of the spring clips is for 6 in. recessed can housings. To install in 5 in. recessed can housings, loosen the two screws in the . brackets holding the spring clips on both sides of the aluminum body using a Philips screwdriver (not included). Slide the brackets holding the spring clips inward until the screws are Bracket in the & in, position, then tighten the screws using a Philips screwdriver | Screw (not included). 2.
