Installation Instructions
INSTALLATION INSTRUCTIONS
3
5. Align torsion springs with receiving brackets
inside of existing recessed housing (A) and
anchor to ceiling by pushing trim up until ush.
Follow instructions on pages 4-5 for Apple IOS
set-up and pages 6-7 for Android set-up.
1. Remove existing light bulb and trim. Conrm that
the existing recessed housing’s inside diameter
is within the range of 5-1/8 in. minimum diameter
to 6-5/8 in. maximum diameter; and that it has a
minimum clearance height of 3-3/4 in.
2. LED Retrot Downlights are pre-set for use with 6
in. diameter housings. For housings with an inside
diameter of 6 in., go to step 3.
To set the torsion spring brackets for cans less
than 6 in. diameter, use a Phillips screwdriver to
loosen the screws on the brackets, then slide each
end in along slotted hole, and re-tighten screws.
3. Screw medium base socket adapter (B) into
socket at top of existing recessed housing.
4. Push together connectors on the lead wires
of the LED Retrot (A) and the socket adapter
(B) until fully seated.
A
B
Fig. 5
Fig. 4
Fig. 3
Fig. 2
Fig. 1
inside
diameter
clearance
height
B
A