Installation Instructions
Before beginning assembly, installation, or operation of product, make sure all parts are present.
Compare parts with package and hardware contents list on page 1. If any part is missing or
damaged, do not attempt to assemble, install or operate the product. Contact customer service for
replacement parts.
SAFETY INFORMATION
PREPARATION
WARNING: These products may represent a possible shock or re hazard if improperly installed or
attached in any way. Products should be installed in accordance with these instructions, current
electrical codes, and/or the current National Electric Code (NEC). Disconnect power to the unit prior
to installation.
WARNING: To reduce risk of re, electric shock, or injury to persons,
• Always be sure that power supply is turned off at fuse box or circuit breaker before installing,
cleaning, or servicing the xture.
• Read and follow all safety instructions
• This luminaire must be installed in accordance with the NEC or your local electrical code
• Suitable for wet location and operation in temperatures not exceeding 122°F (50°C)
• For use in 100-277V, AC application
• Replace the lens if damaged
• There are no serviceable parts inside the xture.
SAVE THESE INSTRUCTIONS. For safest operation, read and become familiar with complete
installation instructions prior to use. Pay close attention to this manual and stay within its guidelines
when using this product.
CAUTION:
• All parts must be used as indicated in this manual. Do not substitute any parts, leave parts out,
or use parts that are worn out or broken. Failure to obey this instruction could invalidate the ETL
certication.
• Do not mount over a sink, tub or shower.
• LEDs emit bright light. Avoid looking directly at the light source.
2
WARNING: PROPOSITION 65
This product can expose you to chemicals including Lead, which is known to the State of California to cause
cancer. For more information go to www.P65Warnings.ca.gov.