Installation Instructions

WARNING
• Turn o󰀨 electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching o󰀨 circuit breaker).
• Be careful not to damage or cut the wire insulation (covering) during xture installation. Do not permit
power cord or housing to contact any surface having a sharp edge. To do so may damage or cut the wire
insulation, which could cause serious injury or death from electric shock.
INSTALLATION INSTRUCTIONS
1. Locate a suitable location for
the xture and cut a 6-5/16 inch
(160mm) round hole where the LED
Ultra-Thin Downlight (A) will be
installed. Ensure this location has
access to electrical wire from the
switch (power supply).
1
6-5/16in
(160mm)
knockouts
electrical
supply
cable
AAA
AAA
2. Carefully open the hardwire
junction box (B) and remove the
appropriate knockout(s).
3. Insert the electrical supply
cable through the knockout and
secure with a cable connector (sold
separately).
4. Using wire nuts, connect supply
cable to hardwire junction box (B)
in the following manner: green to
ground, white to white, black to
black. Place all wiring connections
back into the hardwire junction box
(B) and close the cover.
5. Set the desired CCT by using the
5-position switch within the hardwire
junction box (B).
6. Insert the hardwire junction box
(B) through the mounting hole
established in Step 1.
7. Connect the LED Ultra-Thin
Downlight (A) to the hardwire
junction box (B) by inserting and
twisting the male/female connections
of the attached connector cables
together.
8. Push the spring loaded clips on
the LED Ultra-Thin Downlight (A)
upwards and insert the base of the
LED Ultra-Thin Downlight (A) into
the mounting hole established in
Step 1. Release the clips and the
xture will grip ush with the ceiling/
drywall.
9. Once assembly is complete, turn
on power to conrm the xture is
working properly.
2
3
4
5
6
7
8
9
B
B
B
B
B
2700K 3000K 3500K 4000K 5000K