Installation Instructions

ManualsBrandsPatriot Lighting Elegant Home ManualsLighting & Ceiling FansPatriot Lighting® Elegant Home Cheleste Textured Mahogany Outdoor Wall Light

Page 2 of 4

191113

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install the product.

Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with

package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,

install or operate the product. Contact customer service for replacement parts.

Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,

Safety Glasses, Ladder, Wire Stripper.

ASSEMBLY INSTRUCTIONS

PREPARATION

Turn off the power at fuse or circuit box.

WARNING

● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or

switching off circuit breaker).

● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact

any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury

or death from electric shock.

CAUTION

● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).

Contact your municipal building department to learn about your local codes, permits and/or inspections.

● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician

before installation.

● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use

a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,

do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper

grounding methods as required by the local electrical code in your area.

● If a dimmer control switch is used with this fixture, obtain professional advice to determine the correct type and

electrical rating required.

1. Take the glass shade (C) out from

the frame (D) carefully, then discard

the bubble bags and foams.

3. Attach the mounting plate unit (AA)

to the outlet box using two mounting

screws (BB). Adjust the length of

the preinstalled headless screws if

necessary.

Note: Make sure that the

headless screws are lined up

horizontally to make the fixture

level.

4. Unscrew the finial (F) from the

assembly unit. Remove the cap

(E) from the threaded pipe. Then

insert the threaded pipe into the

hole on the frame (D) (See Fig.4),

then secure it with the cap (E)

and finial (F).

2. Unscrew the two bolt nuts (DD).

Remove the two rubber pads (EE)

and the mounting plate unit (AA)

from the backplate (A).

Headless Screw

Assembly Unit

Threaded

Pipe