Installation Instructions
STEP 7:
a. Confirm that the mounting height is acceptable.
Refer to STEP 3 or STEP5 if changes are
required.
: To make the next step easier, cut the supply
wire and ground wire 24 inches longer than the
distance from the fixture loop to the ceiling.
: Please pay attention to the polarity
(wires labels L & N) when cutting wires. Wire
identification will be needed in STEP 8.
b. Pass supply wires and ground wire through the
quick link and the ceiling canopy and remove any
remaining slack in the wire.
c. Trim excess fixture wire leaving a minimum of 6
inches extending beyond the edge of the ceiling
canopy.
d. Separate the smooth side and ribbed side of the
supply wire to about 3 inches from the end.
e. Using wire strippers, strip each wire ½ inch from
the end.
Note
Important
Supply Wires
and Ground Wire
ASSEMBLY INSTRUCTIONS
5
STEP 9:
A. Re-attach the ceiling canopy to the crossbar
assembly.
b. Secure with the previously removed kunrled nut.
c. Then, attached the lock ball over the ceiling
canopy.
Crossbar Assembly
lock ball
Hex Nut
STEP 10:
a. Install correct bulbs referring to fixture markings and/or labels for maximum wattage.
Your installation is completed now. Restore electricity. Retain this sheet for future reference.
STEP 8:
* Use Wire Connectors (supplied) to connect the
wires.
ground wire green ground
screw
ground screw
ground wire supply
ground
house white wire fixture
supply wire (ribbed sided)
house black (or red) wire
fixture supply wire (smooth side)
outlet box
a) Ground Wire:
1. Wrap supply around
on mounting bracket, no less than 2 in.
from the end of the wire. Tighten .
2. Connect fixture green to
wire with wire connector.
b) Supply Wire:
1. Connect the to the
from fixture identified
with the label “N”.
2. Connect the to the
from fixture
identified with the label “L”.
3. Wrap each connection with approved electrical
tape and carefully stuff all of the connected wires
into the .
WHITE OR RIBBED
BLACK (OR RED) WIRE
FROM SUPPLY
FROM SUPPLY
RIBBED SIDE OF WIRE
FIXTURE
FROM
IDENTIFIED
SMOOTH SIDE OF WIRE FROM
FIXTURE IDENTIFIED
WITH THE LABEL “N”
WITH THE LABEL “L”
GROUND WIRE
GROUND WIRE
FROM SUPPLY
FROM FIXTURE
GREEN GROUND SCREW