Installation Instructions

ASSEMBLY INSTRUCTIONS
3
Outlet Box Screw
Outlet Box
STEP 2:
a. Remove lock ball and Hex Nut from crossbar
assembly (AA).
b. Fit ceiling canopy (B) over the nipple on crossbar
assembly and secure with lock ball.
: The ceiling canopy should be snug against
the ceiling and the lock ball.
If not, adjust the length of the nipple on the crossbar
assembly by unscrewing the preassembled hex
nut.
Then, screw the nipple in or out of the crossbar
until the desired length is achieved.
Once the ceiling canopy is secure, remove the lock
ball and ceiling canopy and proceed to Step 3.
Note
?
?
?
lock ball
Hex Nut
Hex Nut and
Lock Washer
STEP 1:
a. Secure the crossbar (AA) to the outlet box (not
included) with outlet box screws. Tighten until
snug.
: The preassembled mounting nipple on the
crossbar should protrude outward.
Note
AA
B
AA
D
F
E
STEP 3:
a. Choose desired hanging length for the light
fixture. Suggested mounting height over a table or
island is 30 inches from the table/island top to the
bottom of the fixture.
b. Assemble the necessary rods using the 6 inches
rod(s) and/or 12 inches rod(s).
c. Pass supply wires and ground wires through the
rod assembly.
d. Attach the rod assembly to fixture.
e. Hand- tighten until snug.
- Assemble one rod at a time.
- Pass the ground wire through the rod first.
- Then, pass the supply wire through the rod.
- Thread the rod by hand until snug.
Suggested rod length to hang fixture 30 inches
above table top:
- 8 ft. ceiling (2) 12 inch rods + (2) 6 inch rods
- 9 ft. ceiling (4) 12 inch rods + (2) 6 inch rods
- 10 ft. ceiling (6) 12 inch rods + (2) 6 inch rods
: If mounting over an Island, subtract 6 inches
from the lengths listed above.
Note
Rod
STEP 4:
a. Pass supply wires and ground wire through the
fixture loop (C).
b. Thread the fixture loops (C) to the end of each rod.
c. Hand- tighten until snug.
C