Installation Instructions

ASSEMBLY INSTRUCTIONS
STEP 4:
a. The lanyard is provided as a means to support the
fixture from the junction box while connecting the
electrical wires. This enables the fixture to hang
from the junction box and your hands are free to
make the wire connections.
b. Turn the button stop so it may be inserted into the
crossbar slot. Make sure the button stop is
completely inside the crossbar (AA).
c. Slowly release the fixture to make sure it is
supported by the button stop.
d. Proceed to . Once wiring is complete, the
lanyard will push into the junction box when the
Ceiling Canopy is attached to the ceiling.
Step 5
Slot
Button Stop
Lanyard
STEP 6:
a. Coil additional wire and cable inside the canopy.
b. Re-attach the ceiling canopy to the crossbar
assembly.
c. Secure with the previously removed mounting
balls.
d. If fixture is not level, make adjustments to the
cable lengths. Refer to step 3.
WHITE
BLACK (OR RED) WIRE
WHITE
BLACK
FROM SUPPLY
FROM SUPPLY
FROM FIXTURE
FROM FIXTURE
STEP 5:
* Use Wire Connectors (supplied) to connect the
wires.
a) Ground Wire:
1. Wrap supply around
on mounting bracket, no less than 2 inches
from the end of the wire. Tighten .
2. Connect fixture to
wire with wire connector.
b) Supply Wire:
1. Connect the to the
with wire connector.
2. Connect the wire to the
with wire connector.
3. Wrap each connection with approved electrical
tape and carefully stuff all of the connected wires
into the outlet box.
ground wire green ground
screw
ground screw
ground wire supply ground
supply white wire white
fixture supply wire
supply black (or red)
black fixture supply wire
GROUND WIRE
GROUND WIRE
FROM SUPPLY
FROM FIXTURE
GREEN GROUND SCREW
Mounting
Screw
Hex Nut
Mounting Ball
Ceiling Canopy
AA
4
STEP 7:
a. Insert bulbs (B) into fixture sockets.
b.
: Do not touch the bulb with bare
hands, as oil from your skin can damage the bulb;
use a soft cloth or gloves.
Cover with bulb shields (C) only if using
halogen bulbs. Hand tighten until snug.
IMPORTANT
B
C