Installation Instructions

ManualsBrandsPatriot Lighting Elegant Home ManualsIndoor LightingPatriot Lighting® Elegant Home Bodhi Black and Replica Wood 2-Light Pot Rack Island Light

Please read and understand this entire manual before attempting to assemble, operate or install the product.

WARNING

● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or

switching off circuit breaker).

● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact

any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury

or death from electric shock.

● LED electronics can be damaged by electro static discharge (ESD)shock. Before installation, discharge yourself

by touching a grounded bare metal surface to remove this hazard. To avoid damage, do not touch the LED module.

CAUTION

● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).

Contact your municipal building department to learn about your local codes, permits and/or inspections.

● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician

before installation.

● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use

a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,

do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper

grounding methods as required by the local electrical code in your area.

Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with

package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,

install or operate the product. Contact customer service for replacement parts.

Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,

Safety Glasses, Ladder, Wire Stripper.

Page 2 of 3

2. Unscrew four set screws from

fixture(A), and then attach the

trapezoid arch(B) to the fixture(A),

and secure it with four set screws.

Thread the fixture wire and fixture

grounding wire through the rod (D)

and one loop. Secure the rods(D)

to the trapezoid arch(B). Secure

the loop to the rods(D).

Set Screw

ASSEMBLY INSTRUCTIONS

PREPARATION

Turn off the power at fuse or circuit box.

SAFETY INFORMATION

1. Place the mounting bracket

to the outlet box and mark the

target on the wall from the set

hole for drilling two holes.

Remove the mounting bracket

from the outlet box. Thread

anchors (DD) into the holes, and

then attach the mounting

bracket to the outlet box by using two mounting

screws (BB). Secure the dry wall screws (AA) through

the set holes into anchors (DD).

3. - Determine length of chains(GG)

needed to achieve desired fixture

height. (To remove excess chain

section, use pliers to bend link

open.)

Note: Keep the same length for

two chains.

- Weave the fixture wire and fixture

grounding wire through one

chain(GG) and the canopy kit (E).

- Connect one chain(HH) to one

loop and one loop on canopy(E)

using two loop locks(FF).

Repeat it for hanging another chain.

4. Connect the smooth wire to the

black wire (power), the ribbed wire

to the white wire (neutral) with the

wire connectors (CC) provided.

Connect the copper wire on the

light fixture to the mounting

bracket by securing it with the preinstalled grounding

screw, and then connect it to the house grounding wire

with the wire connector (CC).

Tuck all the wires into outlet box.