Assembly Instructions

Sku number: 356-1143

1 LIGHT OUTDOOR WALL LANTERN

Model number: DS18724

Questions, problems, missing parts?

Before returning to your retailer, call our customer service at 1-800-388-6141 ext: 216

Monday - Friday 9:30 a.m. - 3:00 p.m. EST. For customer service support and the fastest

response, please email us at CustomerSupport@DSILighting.com.

HARDWARE CONTENTS (Note: Hardware not shown actual size.)

PACKAGE CONTENTS

Mounting strip

x 1

Support screw

(Pre-assembled to the

mounting strip (AA))

x 2

Hex nut

(Pre-assembled to the

mounting strip (AA))

x 2

Cap nut

(Pre-assembled to the

support screw (CC))

x 2

(Pre-assembled to the

frame (B))

x 2

Thumbscrew

(Pre-assembled to the cap of

fixture body (D))

x 3

40W type ST58 vintage

Edison bulb x 1

Outlet box screw

x 2

Green ground screw

(Pre-assembled to the

mounting strip (AA))

x 1

Rubber washer

x 2

Wire connector

x 3

PAGE 1
Sku number: 356-1143 1 LIGHT OUTDOOR WALL LANTERN Model number: DS18724 Questions, problems, missing parts? Before returning to your retailer, call our customer service at 1-800-388-6141 ext: 216 Monday - Friday 9:30 a.m. - 3:00 p.m. EST. For customer service support and the fastest response, please email us at CustomerSupport@DSILighting.com. PACKAGE CONTENTS A B C D HARDWARE CONTENTS (Note: Hardware not shown actual size.
PAGE 2
SAFETY INFORMATION Please read and understand this entire manual before attempting to assemble, operate or install the product. WARNING • Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or switching off circuit breaker). • Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact any surface having a sharp edge.
PAGE 3
INSTALLATION (continued) 4 CC GG HH AA 4. Place the fixture body (D) over the outlet box, let the heads of support screws (CC) come through the holes of the fixture body (D), then place the rubber washers (GG) over the support screws (CC) and secure by tightening the cap nuts (HH). 5 6. Install the Max 40 watt 7 5. Use weather D resistant caulk (not included) to seal around top and side perimeter of fixture back plate. Do not caulk bottom to allow for condensation evaporation.