Installation Instructions

Please read and understand this entire manual before attempting to assemble, operate or install the product.
WARNING
● Turn off electricity at main fuse box (or circuit breaker box) before beginning installation by removing fuse (or
switching off circuit breaker).
● Be careful not to damage or cut the wire insulation (covering) during fixture installation. Do not permit wires to contact
any surface having a sharp edge. To do so may damage or cut the wire insulation, which could cause serious injury
or death from electric shock.
CAUTION
● All electrical connections must be in agreement with local codes, ordinances or the national electric code (NEC).
Contact your municipal building department to learn about your local codes, permits and/or inspections.
● Risk of fire – most dwellings built before 1985 have supply wire rated for 140°F/60ºC. Consult a qualified electrician
before installation.
● Do not connect this fixture to an electrical system that does not provide a means for equipment grounding. Never use
a fixture in a two-wire system that is not grounded. If you are not sure your lighting system has a grounding means,
do not attempt to install this fixture. Contact a qualified, licensed electrician for information with regards to proper
grounding methods as required by the local electrical code in your area.
Before beginning assembly, installation or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram on previous page. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
Tools Required for Assembly (not included): Screwdriver, Phillips Screwdriver, Pliers, Electrical Tape, Wire Cutters,
Safety Glasses, Ladder, Wire Stripper.
Page 2 of 4
PREPARATION
ASSEMBLY INSTRUCTIONS
Turn off the power at fuse or circuit box.
SAFETY INFORMATION
4. Install a bulb (not included).
See relamping label at socket
area or packaging for
maximum allowed wattage.
4
3
HH
GG
A
Bulb Type A Max.60W
(not included)
1. Thread two headless screws(CC)
through the mounting plate(AA),
and then secure them with four
lock nuts(DD) (two on each side of
the mounting plate(AA)). Adjust the
length of the headless screws(CC)
if necessary.
Note: Make sure that the
headless screws are lined up
horizontally to make the fixture level.
Attach mounting plate(AA) to the outlet box using two
mounting screws(BB).
1
AA
BB
DD
CC
2. Pull out the source wires from the
outlet box. Make wire connections
using wire connectors (FF) as
follows:
• Connect the hot wire (usually
black insulation) from the fixture
to the black wire from the power source.
• Connect the neutral wire (usually white insulation)
from the fixture to the white wire from the power
source.
• Attach the fixture grounding wire (usually green
insulation or bare wire) to the mounting plate (AA) with
the green grounding screw (EE), and then connect it to
the house grounding wire with the wire connector (FF).
Carefully put all of the wires back into the outlet box.
FF
AA
2
EE
3. Attach the back plate (A) to
the mounting plate (AA) by
inserting headless screws (CC)
into holes on back plate (A), and
then secure them with two rubber
pads (HH) and two ball nuts (GG).
CAUTION:With silicone
caulking compound, caulk
completely around where the back plate meets with
the wall surface to prevent water from seeping into
the outlet box.