Installation Instructions

PAGE: 7 / 10 PAGE: 8 / 10
ASSEMBLY INSTRUCTIONS (continued) ASSEMBLY INSTRUCTIONS (continued)
4. ELECTRICAL HOOK-UP
120 V
SUPPLY CIRCUIT
Fan
3. INSTALL MOUNTING BRACKET
- Install J-Hook through center of outlet box into the wooden joist.
- Secure mounting bracket and rubber gaskets to outlet box.
- Hang fan on mounting bracket and install safety cable onto the J-Hook.
WARNING: To Reduce The Risk Of Fire, Electric Shock, Or Personal Injury, Mount
To UL/CSA Listed Outlet Box Marked Acceptable For Fan Support And Use Mounting
Screws Provided With The Outlet Box.
Wood
Joist
Outlet
Box
Rubber
Gasket
Mounting
Bracket
Outlet box screws
(not provided)
Ceiling
J-Hook
- This fan is equipped with a remote control unit for controlling the fan speeds and light kit.
- To set the code on the hand-held remote and the receiver:
#1- Remove the battery cover on the hand-held remote
(Press firmly below the arrow and slide the battery cover off).
#2- Set code switches to desired position on the receiver and
on the remote.
#3- Replace the battery cover on the hand-held remote.
- Make the following wire connections to the receiver unit using the wire nuts supplied.
- Connect GREEN fan wire to BARE (ground) wire.
- Connect BLACK receiver unit wire to BLACK supply wire.
- Connect WHITE receiver unit wire to WHITE supply wire.
- Connect WHITE receiver unit wire (MOTOR N) to WHITE fan wire.
- Connect BLACK receiver unit wire (MOTOR L) to BLACK fan wire.
- Connect BLUE receiver unit wire (FOR LIGHT) to BLUE light wire.
- After making the wire connections, ensure all wires are spread
apart with the grounded conductor and the equipment-grounding
conductor on one side of the outlet box and the ungrounded conductor
on the other side of the outlet box.
- Ensure the splices after being made are turned upward and
pushed carefully up into the outlet box.
4. ELECTRICAL HOOK-UP
A
B
B
NOTE: Once ground wires are connected, carefully tuck all wires and marrettes into
the metal outlet box making sure that the wires are clear of the hemisphere and
downrod when positioned in mounting bracket.
- Place two screws and washers on mounting plate (marked B on diagram) which
correspond with slots in canopy. Screw in two turns.
- Position canopy to mounting plate aligning slots to screws (marked B on diagram)
then turn to lock.
- Position and tighten the two screws and washers (marked A on diagram) then tighten
the two screws (marked B on diagram).
5. MOUNTING FAN ASSEMBLY
a.
a.
b.
Canopy
J-Hook
Safety
Cable
b.
Canopy
Safety
Cable
c.
Temporary
Hook
C
- Push all connected wires up into ceiling box.
- Slide the receiver into the mounting bracket as shown below.
Reciever
Mounting
Bracket
Canopy
c.
Diagram b is for Downrod Mount.
Diagram c is for Flush Mount.