Installation Instructions

PAGE: 5 / 10 PAGE: 6 / 10
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS (continued)
1. ATTACH THE FAN BLADES
NOTE: All set screws must be checked and retightened where necessary,
before and after installation.
2. MOUNTING
DOWNROD MOUNT
- Attach the blades to the
fan motor assembly using
the screws, metal washer
and fiber washer (
supplied
in hardware package).
Slightly turn the blade after
installation and repeat the
same step for the other
blades.
- Re-attach the cover to
the top housing.
Metal Washer
Blade Bracket Screw
Blade
Blade Bracket
Screw
Slide Switch
Screw
Fiber Washer
- Remove cotter pin, metal
washer and bolt from
yoke. Also need to
remove jam screws before
removing top housing
cover.
Remove the cover
on the top housing.
a.
b.
c.
d.
e.
- Loosen jam screws in yoke until it is flush with the inside surface.
- Obtain downrod, canopy and yoke cover.
- Place downrod inside canopy and yoke cover.
- Route wires exiting motor through yoke cover, canopy and downrod.
- Insert bolt through hole in yoke and downrod. Be careful not to damage or cut the fan wires.
- Place flat washer over end of bolt and insert cotter pin through hole in the end of the bolt.
- Secure downrod in position by tightening jam screws. Slide yoke cover down so it is flush
with the motor housing.
A
B
FLUSH MOUNT
- Remove rubber ring from canopy
- Remove the Motor cover housing by aliging 3 screws.
- Place rubber bushing on Motor housing aligning the 3 smaller holes.
- Place canopy on Motor housing, align the 3 smaller holes on canopy
to holes on Motor housing
- Remove the 3 screws and washers from the top of the motor. Secure Canopy to the
motor housing by replacing 3 screws and washers in the 3 smaller holes in canopy.
Canopy
Rubber Ring
Motor
Canopy
Yoke Screws
& Washers
Rubber
f.
g.
a.
b.
c.
Bushing
Motor
Bolt
Yoke
Jam
Screw
Jam
Screw
Downrod
Canopy
Yoke
Cover
Bolt
Flat
Washer
Cotter Pin
Yoke
Jam
Screw
Cotter
Flat
Washer
Pin