Datasheet

BSV-24.-PDFD-EN-15_16
2. Save the created file on an SD card.
 An error occurs when a file of two or more operational modes is saved on an
SD card.
4-7 Data Transfer
The data saved on SD card by "4-5. Changing the Voice Message Data", and "4-6.
Changing the Operation Mode Data" can be transmitted to a product.
 When the data of both "4-5. Changing the Voice Message Data" and "4-6.
Changing the Operational Mode Data" is saved on an SD card; data transfer can
be performed simultaneously.
 When saving data onto the SD Card using both the "4-5-1. When using PATLITE’s
Playlist Editor” and the "4-5-2. When not using PATLITE’s Playlist Editor ", the data
from the "4-5-1. When using PATLITE’s Playlist Editor " is given priority.
1. Please check that the products power source is turned on.
2. Please insert the SD card with the saved data into the SD card slot.
3. The sound of a high-low beep will indicate that the data transfer is started.
 During the upload of the data from the SD card, any signal inputs will be
ignored.
 When the SD card is inserted during a voice message playback, the data
transfer will start after the end of the message playback.
4. When the sound of a short beep is heard to indicate that the data transfer has
successfully been completed, please extract the SD card. Uploading should be
completed within 60 seconds. When a short intermittent beep or long
intermittent beep is heard, or if nothing occurs at all, the data transfer was not
successfully completed. As a caution, please be sure the volume is adjusted to
a nominal level, or the indicating beep will not be heard.
5. After data has been uploaded, verify the message contents and operation of the
product is programmed as expected.
* All MP3 registered messages for the BSV-24□M-□ will be erased if written over.