User Manual
Contact us for assistance: (866) 985-7877 | www.wtliving.com 5
ASSEMBLY
CHAIR ASSEMBLY
4
Attach the Backrest
D
to the Seat
E
by inserting the
pre-installed studs on the Backrest into the two holes on
the Seat. Secure with a Washer/Spring Washer/Nut on
each stud. Tighten securely but do not overtighten.
Repeat to begin assembling second chair.
5
Turn the unit upside-down. Attach the Chair Legs
F
to
the
Seat E by placing the holes in the top of each Leg over the
pre-installed studs on the bottom of the Seat. (NOTE: it is
easier to begin with the REAR legs and then attach the
FRONT legs.) Secure each Leg by sliding a Washer/Spring
Washer H onto each stud, then tightening on a Nut H.
Repeat to complete second chair.
6
Finally, cover all Nuts with Plastic Caps I/H.
Tighten ALL
nuts on table and chairs using
Wrench K.
H
E
D
H
E
F
4
5
6
H
D
Your Bistro Set is ready for use!
Hardware: H Washer/Spring Washer/Nut/Cap (8mm) x 4
Hardware: H Washer/Spring Washer/Nut/Cap (8mm) x 16