User Manual

Contact us for assistance: [phone] | www.wtliving.com 4
ASSEMBLY
1
Lay the Table Top
A
upside down on a clean, soft, level surface.
Screw 3 Studs into the threaded holes on the bottom of the
Table Top.
2
Fit a Table Leg V over one of the Studs J and secure in
position by sliding a Washer/Spring Washer H over the
Stud, then fastening with a Nut H. Tighten with the
Wrench
K, then cover the Nut with a Plastic Cap H.
Repeat to install the other two Legs.
3
Carefully turn the assembled Table
Top/Legs upright.
Align the bolt holes on the Leg Brace
C
with the
brackets on the Legs B and insert a Bolt G in each hole.
Secure each Bolt by sliding on a Washer/Spring
Washer I and fastening with a Nut I. Tighten all Bolts
and Nuts securely, but do not overtighten. Cover each
Nut with a Plastic Cap I.
Hardware: G Bolt (6x35mm) x 6
I Washer/Spring Washer/Nut/Cap (6mm) x 6
PREPARATION
Before beginning assembly, be sure to empty contents of carton and make sure all parts are present. If any parts are
missing, please contact Customer Service at (866)-985-7877, Monday-Friday, 9 a.m. - 6 p.m. EST or email at
[e-mail].
Place all parts on a soft, level surface for assembly. Estimated Assembly Time: 30 Minutes | DO NOT over tighten hardware!
You will need a Phillips head screwdriver for assembly.
TABLE ASSEMBLY
J
J
J
A
B
H
G
A
B
C
I
1
2
3
A
Hardware: J Stud (8x30mm)
x 3
Hardware: H Washer/Spring
Washer/Nut/Cap (8mm) x 3