Instructions / Assembly

 
ASSEMBLY
4
5
6
D
E
1
1
B1
B2
C
3
3
3
A
B2
B1
D
2
2
2
2
2
7
7
G
4
5
6
4
5
5
7
4
G
Attach the Wheels
G to the Axle: slide a Wheel Spacer 6, then a
Wheel onto each end of the Axle. Place a Washer onto each of 2
Screws
4, then use the Hex Wrench to tighten the Screws into
either end of the Axle. Do not over-tighten, as the wheel will need
to move freely.
Your Sanur Lounger is now assembled! Carefully turn it upright.
Hardware: 4
Screw (6x40mm) x 2
5 Washer x 2
6 Wheel Spacer x 2
To adjust the angle of the back rest, simply lift the back rest
and fit the support bar into the desired notch.
The Sanur Lounger comes with an adjustable slide-
away table that can be pulled out on either side of
the seat for easy access to light items such as a
beverage or book. Do not use the sliding table as a
seat or step.