Instructions / Assembly
ASSEMBLY
1
2
3
B1
B2
C
3
3
3
A
B2
B1
D
2
2
2
2
2
7
7
4
5
6
F
F
6
4
5
7
5
4
D
E
1
1
A
B2
B1
D
2
2
2
2
2
7
4
5
6
F
F
6
4
5
7
5
4
D
E
1
1
B1
B2
C
3
3
3
7
4
5
6
F
F
6
4
5
7
5
4
Find the Front Legs B/C and the Front Leg Brace D. Fit the
pegs at the end of the Leg Brace into the oval-shaped holes
on the inside of each leg, as shown. Fasten the Legs to the
Front Leg Brace by inserting a Screw 3 through each Leg
and into the Front Leg Brace. Tighten both with the Hex
Wrench 7.
3
7
D
3
B
C
3
Hardware: 3 Screw (6x50mm) x 2
Find the Wheeled Legs E and the Axle F. Insert the Axle
through the holes drilled in the wide surface of the
Wheeled
Legs as shown, making sure that the curve of each Leg faces
the same direction. Align the drilled holes near either end of
the Axle with the the drilled screw holes in the short edge of
each Leg. Insert a Screw 1 into each hole and into the Axle.
Tighten both with the Hex Wrench 7.
Hardware: 1 Screw (4x35mm) x 2
Before beginning assembly, be sure to empty contents of carton and make sure all parts are present. If any parts are missing,
please contact Customer Service at (866)-985-7877, Monday-Friday, 9 a.m. - 6 p.m. EST or email at cservice@welltraveled.net.
Place all parts on a soft, level surface for assembly. Estimated Assembly Time: 30 Minutes | DO NOT over tighten hardware!
PREPARATION
Turn the Lounger Frame A face-down on a soft, level surface.
Identify the foot-end of the frame by finding the two oval-
shaped handles cut into the wood frame.
Attach the Front Legs (assembled in Step 1) by inserting the top
portion of each Leg
into the holes in either side of the frame
near the handles. (NOTE: the curve of the legs should sweep
toward the foot-end of the Lounger Frame.) Using two Screws
2 per Leg as shown, fasten the Front Legs to the Lounger
Frame.
Attach the Wheeled Legs to the head-end of the Lounger
Frame in the same manner. (NOTE: the curve of the legs should
sweep toward the head-end of the Lounger Frame.)
Tighten all 8 Screws using the Hex Wrench 7.
E
F
1
1
C
B
E
2
2
2
2
2
7
A
Hardware: 2 Screw (6x20mm) x 8