Use and Care Manual

1 2

Assembly

1. As shown below, insert grill guard (N) into the gaps between steel board (#1,#2) and

heater housing (M). Screw together using tapping screws (0).

2. As shown below, put lower tube (H) through the hole of the base cover (I) and base (J)

making sure the end of lower tube with welded plate is downward, and the extra tongue

is located in the sink of the base. Fix lower tube and base together with washer (K) and L

screw (L).

3. Install middle tube (G) on top of lower tube. Pull straight tube (B) upward from inside

of upper tube (D). Screw outer fastener (C) clockwise to lock it. Then install upper tube

(D) on middle tube (G).

4. Turn outer fastener counter-clockwise and adjust the unit to desired height. Turn it

clockwise to lock into position.

5. Insert straight tube (B) into hole on bottom of control box (A). Then fix them together

with screw (E).

6. Clip power supply cord with cord clips (F). Fix them onto the tubes.

7. As shown below, the tilting of the heater is adjustable for 25°. Adjust it to desired angle

when necessary.

Operation

1. Plug the unit into a socket. Make sure the power supply is same as rated. The blue

indicator light starts flashing, which means it’s in standby status.

2. Press “ON” button on the control panel or the remote controller to switch on the

heater. Then the blue indicator lights up.

3. To switch off the heater, press the “OFF” button on the control panel of the heater.

After pressing the “OFF” button on the control panel, the blue indicator light should

turn off. Pressing the “OFF” button on the remote control with shift the heater to

standby status and the blue indicator light will flash.

1 2