Use and Care Manual
Adjustable Height Standing Patio Heater w/ Remote Control
Sku: 101010
Please keep this instruction manual for future reference
Read the instructions and precautions before use of this product
For warranty information, please refer to the back page of
this instruction manual.
Important Instructions Continued
33. Surface temperatures become very hot when operating heater. Children and adults should stay away to avoid burns
or clothing ignition.
34. Young children should be carefully supervised when they are in the area of the heater.
35. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left
operating and unattended.
36. Always unplug heater when not in use.
37. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or
damaged in any manner. Discard heater, or return to authorized service facility for examination and/or repair.
38. Connect to properly grounded outlets only.
39. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock
or fire, or damage the heater.
40. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed,
where openings may become blocked.
41. A heater has hot and arcing or sparking parts inside. Do not use it in areas where gasoline, paint, or flammable
liquids are used or stored.
42. This heater may include an audible (a visual) alarm to warn that parts of the heater
are getting excessively hot. If the alarm sounds (flashes), immediately turn the heater
off and inspect for any objects on or adjacent to the heater that may cause high
temperatures. DO NOT OPERATE THE HEATER WITH THE ALARM SOUNDING
(FLASHING). (Omitted if an alarm is not required per Alarms, Section 30.)
CAUTION: EXTEND OR UNFOLD LEGS BEFORE OPERATING
Grounding Instructions:
This heater is for use on 120 volts. The cord has a plug as shown at A in Figure below. An adapter as shown at C is
available for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding lug extending
from the adapter must be connected to a permanent ground such as a properly grounded outlet box. The adapter should
not be used if a three-slot grounded receptacle is available
Cleaning:
Unplug the unit before cleaning. It should be wiped with wet cloth. Don't use too much water. Any other servicing should
be performed by an authorized service representative.