AMBIANCE MANUAL

ASSEMBLY INSTRUCTIONS
1.Insert the hoods of bottom plate (O) to the
lower holes of the three lower supports (K)
Insert the hoods of control box assembly (J)
to the upper holes of the three lower support
(K).
Note: Make sure to align the side of bottom
plate (O) with the holes (to accommodate front
plate P) with the side of control box assembly
(J) with the magnet.
2. Insert three upper supports (E) to the three
lower supports (K). Please note: be sure that
the upper support (E) slide down completely
into the lower supports (K) before attempting
to install screws.
1
J
K
O
2
E
6
Note… Bottom Plate with tank retention
hole has folded edges facing up.