AMBIANCE MANUAL

OPERATION INSTRUCTIONS
9. Fire feature is away from gasoline or other flammable liquids or vapors.
10. Fire feature is away from windows, air intake openings, sprinklers and other water sources.
11. Fire feature is located at least 24" (top) / 36" (sides) from combustible materials.
12. Fire feature is on a hard and level surface.
13. There are no signs of spider or insect nests.
14. All burner passages are clear.
15. All air circulation passages are clear.
16. Children and adults should be alerted to the hazards of high surface temperatures and
should stay away to avoid burns or clothing ignition.
17. Young children should be carefully supervised when they are in the area of the fire feature.
18. Clothing, combustible materials or other protective material should not be hung from the fire
feature, or placed on or near the fire feature.
19. Any guard or other protective device removed for servicing the fire feature must be replaced
prior to operating the fire feature.
20. Any repair of this fire feature should be done by a qualified service person. The fire feature
should be inspected before use and at least annually by a qualified service person.
21. More frequent cleaning may be required as necessary. It is imperative that control
compartment, burner and circulating air passageways of the fire feature be kept clean.
After Operation be Certain:
Gas control is in OFF position. Gas tank Valve is OFF. Disconnect Propane gas cylinder.
CARE AND MAINTENANCE
WARNING
FOR YOUR SAFETY:
• Do NOT touch or move fire feature for at least 45
minutes after use.
• Reflector is hot to touch.
• Allow reflector to cool before touching.
To enjoy years of outstanding performance from your fire feature, make sure you perform the
following maintenance activities on a regular basis:
1. Keep exterior surfaces clean. Use warm soapy water for cleaning. Never use flammable or
corrosive cleaning agents. While cleaning your unit, be sure to keep the area around the burner
and pilot assembly dry at all times. Do not submerge the control valve assembly. If the gas control
is submerged in water, do NOT use it. It must be replaced.
2. Keep the appliance area clear and free from combustible materials, gasoline and
other flammable vapors and liquids.
3. Do not obstruct the flow of combustion and ventilation air.
4. Keep the ventilation opening(s) of the cylinder enclosure free and clear from debris.
5. Air flow must be unobstructed. Keep controls, burner, and circulating air passageways clean.
6. Regularly replace AA Battery behind ignitor button (as needed)
7. Remove and thoughouly clean control box assembly using compressed air annually, if Ambiance
Fire Feature pilot fails to light or as needed.
18