User's Manual

DRAFT
PassiveBolt Inc. | 330 E Liberty St, Suite 3D, Ann arbor, MI 48104 | 6/18/2020
Page 3 of 3
4.4 FCC Labeling Requirements
Please see the operational description for details on host product labeling
4.5 FCC Approved Antennae
Please see the operational description for details on the antenna approved or use with this module.
4.6 FCC Limitations on Changes or Modifications
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
4.7 ISED Canada Notices
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation of
the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
4.8 ISED Canada Modular Approval Limitations
Please see the operational description for details on the modular approval limitations.
4.9 ISED Canada Labeling Requirements
The host device shall be properly labelled to identify the modules within the host device. The Industry
Canada certification label of a module shall be clearly visible at all times when installed in the host
device, otherwise the host device must be labelled to display the Industry Canada certification number of
the module, preceded by the words “Contains transmitter module”, or the word “Contains”, or similar
wording expressing the same meaning, as follows:
“Contains transmitter module IC: 26054-GNMOD090004”
“Contient le émetteur radio IC: 26054-GNMOD090004”
4.10 ISED Canada Approved Antennae
All RF ports of the GNMOD090004 module have been approved for use with only the following external
antennas: Patch antenna (PassiveBolt PN: GN.MOD.9.1.1.4) and a 3 dBi Dipole antenna (PassiveBolt
PN: W177970AS14). Antennas of equal or lesser gain and of the same type may be substituted.