User's Manual

DRAFT
PassiveBolt Inc. | 330 E Liberty St, Suite 3D, Ann arbor, MI 48104 | 6/18/2020
Page 2 of 3
4 Company Information
PassiveBolt Inc.
330 E. Liberty St.,
Suite 3D,
Ann arbor, MI 48104
[e-mail]
4.1 RF Exposure Notice
This equipment complies with FCC and ISED radiation exposure limits set forth for mobile use
environment. Users of this device must ensure that the module be installed and/or configured to operate
with a separation distance of 20cm or more from all persons. This transmitter module must not be co-
located or operating in conjunction with any other antenna or transmitter.
Cet équipement est conforme aux limites d'exposition aux rayonnements FCC et ISDE établies pour un
environnement d'utilisation mobile. Les utilisateurs de cet appareil doivent s'assurer que le module est
installé et / ou configuré pour fonctionner avec une distance de séparation de 20 cm ou plus de toutes les
personnes. Ce module émetteur ne doit pas être situé à proximité ou fonctionner en conjonction avec une
autre antenne ou un autre émetteur.
4.2 FCC Compliance Notices
The GNMOD090004 device complies with Part 15 of the FCC rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
 Consult the dealer or an experienced radio/TV technician for help.
4.3 FCC Modular Approval Limitations
Please see the operational description for details on the modular approval limitations.