Service and Repairs

4
Step 1
Spray the Cylinder Head with cleaner/degreaser.
Allow the dirt and debris to drip off.
CLEANER/DEGREASER RUN INTO THE
HANDLE.
Step 2
Using a clean, lint-free rag, wipe off any remaining
cleaner or dirt. Make sure the Seal Rings and
Spark Plug
are completely clean and clear of de-
bris. Repeat Step 3 to remove any heavy deposits
or remaining residue.
Step 3
Thoroughly lubricate the Seal Rings with Paslode
Cordless Lubricating Oil, part #401482. Make
sure oil is applied evenly around entire
Seal Ring.
Set the Handle/Cylinder Head Assembly aside.
Note:
Paslode Cordless Lubricating Oil is specially
formulated for use in the Paslode Cordless
Nailer. The use of other types of lubri-
cants may cause rapid build-up of combustion
residue or result in premature part failure.
Cylinder Head
Framing
DO NOT LET OVER SPRAY OR DIRTY
Before reassembly, ensure the position of the
away from each other, after lubricating.
gap of the 2 X seal rings are 180 degrees, facing