Instruction Manual
700 kPa MAX
DRY AIR ONLY
PRESSURE PORT MATING
CONNECTOR:
PASCO PART NO. 640-021
PRESSURE
SENSOR
0-700 kPa
(ABSOLUTE)
CI-6532A
Instruction Sheet
for the PASCO
Model CI-6532A
PRESSURE SENSOR - ABSOLUTE
(0 TO 700 kPa)
012-06859B
10/98
$1.00
© 1998 PASCO scientific
quick release
connectors (4)
Pressure Sensor
unit
to computer
interface
cable with DIN
connectors
pressure port
connector
polyurethane
tubing
syringe
Introduction
The PASCO Model CI-6532A Pressure Sensor-
Absolute is designed to be used with a PASCO
Science Workshop
®
computer interface. The CI-
6532A includes the pressure sensor unit,
extension cable with 8-pin DIN connectors, quick
release connectors, polyurethane tubing, and a
syringe.
The pressure sensing element in the pressure
sensor unit has two pressure ports. One port is
connected to the atmosphere via the pressure port
connector at the front of the pressure sensor unit.
The other port is internal to the pressure sensing
element and is sealed with a reference vacuum.
The sensor element is designed to be used with
non-corrosive gases such as air, helium, nitrogen,
etc. Do not expose the sensor to liquids.
Equipment
INCLUDED
• Pressure Sensor (Absolute) unit
• quick-release connectors (4)
• polyurethane tubing (0.6m)
• plastic syringe (20cc, calibrated)
ADDITIONAL REQUIRED
• computer (PC or Macintosh)
• Science Workshop
®
computer interface
• Science Workshop
®
software version 2.2. or
higher
Extra parts are available as follows:
Item Part Number
plastic syringe 699-084
polyurethane tubing 640-023
quick-release connector 640-021