Manual

Model No. AP-8214A 012-13282A DataStudio Set-up

• Change the name of the data run (Run #1) containing the calibration data to “Cal”.*

DataStudio Set-up

1. Prepare the calculation for “Calibrated Displacement(F)”. In the Calculator window, select the “Cali-

brated Displacement(F)” calculation and define the variables.

• Drag “Displacement(t) vs Coupon Force(t) (mm)” to “Please define variable ‘Displacement’.” (Figure 13)

• Drag “Cal” to “Please define variable ‘Cal’” in the Calculator window. (DataStudio will display a warning

box stating that a “single run is selected”. Click the Yes button in that box.)

2. Prepare the calculation for “Stress(F)”. In the Calculator window,

select the defined function “Stress(F) = Force/Area”. In the Vari-

ables section, enter the cross-sectional Area of the coupon in square

millimeters. See the Test Coupons Specifications section for the

cross-sectional Area. (The cross-section Area in this example is

0.303.)

* To rename a data run, click the run name (e.g. “Run #1”) where it appears in the Data List. Wait about 1 second

then click it again. Enter the new name. A dialog box will appear. Select Yes. (If a window titled “Data Properties”

appears, you didn't wait long enough after the first click; close that window and try again.)

Fig. 13: Define Variables in Calculator