User's Manual

ME-9447B 012-13471A Introduction
®
5
String Tie fit into the rectangular holes in the recess. Align the short “legs” with the shallow notches. Insert one
“leg” into one of the rectangular holes and then press down firmly on the other side of the String Tie until the other
“leg” snaps into the other rectangular hole. NOTE: Press firmly. When the String Tie is correctly inserted, the top
surface of the clear plastic disk will be flush with the surface of the Force Table.
To remove the String Tie from the Force Table, turn the Force Table over and press the two short “tabs” of the
String Tie inward toward each other.
Setup
Arrange the strings over the pulleys. Attach a mass hangers to each string. NOTE: A string can be attached to a
PASCO mass hanger by wrapping the string four or five times around the notch at the top of the mass hanger.
1. Insert one “leg” into one
of the rectangular holes.
2. Press firmly to push the
other “leg” into its hole.
String Tie
NOTE: Masses and mass
hangers are not included.
Clamp shown with
the pulley yoke in
the lower position..