User's Manual

Super Pulley Force Table Introduction
®
4
• Assemble the Force Table
• Turn the Force Table upside
down..Remove a leg from its storage clip
and holder.
• Line up the leg screw with a threaded
hole in the underside of the Force Table.
• Rotate the leg clockwise (left-to-right)
until it is firmly attached to the table.
• Repeat for the other legs.
NOTE: Do not tighten the legs more than
“finger tight”. They will be removed later for
storage.
• Turn the Force Table right side up.
Attach the Pulleys
Attach three of the ME-9448B Super Pulley
with Clamp to the edge of the force table.
Each clamp has two positions for holding the
pulley yoke. You may want to move the pul-
ley yoke to the lower position so that the top
edge of the pulley can be more easily aligned
with the top surface of the table. To do this,
unscrew the thumbscrews on both sides of the
clamp. Arrange the pulley yoke so the holes
in the yoke are aligned with the lower
threaded holes of the clamp. Replace the two
thumbscrews but do not overtighten. NOTE:
Each thumbscrew has a slotted head. If the
thumbscrew is too tight, use a flat blade
screwdriver to loosen it.
NOTE: If more than two forces are to be
added, use the desired number plus one pulley
and clamp for the equilibrium force.
Attach the Strings.
Get three pieces of string (thread), each about 30 centimeters long. Twist
the ends of the strings together and thread the three strings through the
hole in the middle of the clear plastic disk on the String Tie Assembly.
Pull the ends of the threads through the hole and tie them together with an
overhand knot so that the strings cannot be pulled back through the clear
plastic disk
Insert the String Tie Assembly
The String Tie Assembly fits into the circular recess in the middle of the Force Table. The circular recess has two
rectangular holes in the bottom and two shallow notches on its edge. The two short “legs” of the outer part of the
Storage
clip
Threaded
hole
Leg
holder
Underside of
Force Table
1. Remove a leg from its
storage clip and holder.
2. Line up the leg screw
with a threaded hole.
3. Rotate the leg into the
threaded hole.
1.
2.
3.
ME-9448B
Super Pulley
with Clamp
Clamp
Thumbscrew
Yoke
Storage recess
Stacking
peg
String
Tie the ends
together.