User's Manual

PASCO Compression Igniter 012-13028B Material Safety Data Sheet
®
8
DOW CORNING CORPORATION
Material Safety Data Sheet
Page: 3 of 7
Version: 1.5
Revision Date: 2011/01/28
DOW CORNING(R) 111 VALVE LUBRICANT & SEALANT
Containment/Clean up: Observe all personal protection equipment recommendations described in Sections 5 and 8.
Wipe up or scrape up and contain for salvage or disposal. Clean area as appropriate since spilled materials, even in small quantities, may present a slip hazard. Final cleaning may require use of steam, solvents or detergents. Dispose of saturated absorbant or cleaning materials appropriately, since spontaneous heating may occur. Local, state and federal laws and regulations may apply to releases and disposal of this material, as well as those materials and items employed in the cleanup of releases. You will need to determine which federal, state and local laws and regulations are applicable. Sections 13 and 15 of this MSDS provide information regarding certain federal and state requirements.
Note: See Section 8 for Personal Protective Equipment for Spills. Call [phone], if additional information is required. 7. HANDLING AND STORAGE Use with adequate ventilation. Avoid eye contact. Use reasonable care and store away from oxidizing materials. This material in its finely divided form presents an explosion hazard. Follow NFPA 654 (for chemical dusts) or 484 (for metal dusts) as appropriate for managing dust hazards to minimize secondary explosion potential. 8. EXPOSURE CONTROLS / PERSONAL PROTECTION Component Exposure Limits
There are no components with workplace exposure limits.
Engineering Controls
Local Ventilation: None should be needed. General Ventilation: Recommended.
Personal Protective Equipment for Routine Handling
Eyes: Use proper protection - safety glasses as a minimum. Skin: Washing at mealtime and end of shift is adequate. Suitable Gloves: Handle in accordance with good industrial hygiene and safety practices. Inhalation: No respiratory protection should be needed. Suitable Respirator: None should be needed.
Personal Protective Equipment for Spills
DOW CORNING CORPORATION
Material Safety Data Sheet
Page: 4 of 7
Version: 1.5
Revision Date: 2011/01/28
DOW CORNING(R) 111 VALVE LUBRICANT & SEALANT
Eyes: Use proper protection - safety glasses as a minimum. Skin: Washing at mealtime and end of shift is adequate. Inhalation/Suitable Respirator:
No respiratory protection should be needed.
Precautionary Measures: Avoid eye contact. Use reasonable care.
Note: These precautions are for room temperature handling. Use at elevated temperature or aerosol/spray applications may require added precautions. 9. PHYSICAL AND CHEMICAL PROPERTIES
Physical Form: Grease
Color: Translucent white
Odor: Odorless
Specific Gravity @ 25°C: 1.1
Viscosity: Not determined.
Freezing/Melting Point: Not determined.
Boiling Point: Not determined.
Vapor Pressure @ 25°C: Not determined.
Vapor Density: Not determined.
Solubility in Water: Not determined.
pH: Not determined.
Volatile Content: Not determined.
Flash Point: > 214 °F / > 101.1 °C (Closed Cup)
Autoignition Temperature: Not determined.
Flammability Limits in Air: Not determined.
Note: The above information is not intended for use in preparing product specifications. Contact Dow Corning before writing specifications. 10. STABILITY AND REACTIVITY
Chemical Stability: Stable. Hazardous Polymerization:
Hazardous polymerization will not occur.
Conditions to Avoid: None. Materials to Avoid: Oxidizing material can cause a reaction.
Hazardous Decomposition Products Thermal breakdown of this product during fire or very high heat conditions may evolve the following decomposition products: Carbon oxides and traces of incompletely burned carbon compounds. Silicon dioxide. Formaldehyde.