User's Manual

®
Cast Beam Structures Set ME-7009
7
Bridge Test Fixture
The image shows a bridge structure with a Cast Beam member. The load is applied by a hanging mass suspended from a cross
member, and the tension through the Cast Beam is measured with a 100 N Load Cell (PS-2201).
Typical Test Results
Stress/Strain Test Fixture
The PASCO Stress/Strain Apparatus (AP-8213) can be used to test the strength of the Rebar Member by itself. Use diagonal pliers
or strong clippers to cut the ends off the two pieces of “rebar” in the Rebar Member. Mount a single piece of “rebar” into the two
Coupon Clamps on the Stress/Strain Apparatus. Turn the crank clockwise to apply tension to the “rebar” until it fails (breaks)..
#3
#3
#4
#4
#4
Cast
Beam
Hanging Mass
Load
Cell
#2
#2
Rotary
Motion
Sensor
Force
Sensor
Rebar
Member
Coupon
Clamp
Coupon Clamp
Sample Data