User's Manual

®
Model No. ME-6984 Fork Lift
9
Fork Lift
Extra Equipment Model
Hooked Mass Set SE-8759
Large Slotted Mass Set ME-7566 or ME-7489
Yellow Cord (2 pack) ME-9876
Foam core board not included
#5
#5
#5
#4
#4
#4
3 X4
#4
#3
Angle
Connector
Angle
Connector
#2
#2
#3
#3
#3
Sliding
Connector
Axle
(Medium)
Sliding
Connector
Cord
Tensioning
Clip
Axle
(Medium)
Full
Round
Full
Round
Axle
(Long)
Syringe
Coupler
Bleeder
Valve
Check
Valve
Assembly
C
#4
#2
Hooked
Mass
A
C. Place large slotted
masses at the end of the
base as a counterweight.
A. Put a short axle
through the longer
hole in the piston cap.
Half
Round
B
B. Put collets on both sides of
the trunnion at the bottom of the
hydraulic cylinder.
Yellow
Cord
Ye l l o w
Cord
#2
#1
Cord
Flat
Round
#3
Support for slotted masses
Cord detail
Sliding
Connector
Sliding
Connector
Tie one end of the
cord to the middle
of the #3 beam.
Ye l l o w
Cord
Full
Round
Cord
Tensioning
Clip
Sliding
Connector
E. Tighten the cord so that it is
parallel to the top of the boom
when the base of the fork lift
is parallel to the ground.
E. Base of fork lift is
parallel to the ground
E. Cord is parallel to
the top of the boom
D. Tie cords diagonally to
cross-brace the back of
the base.
D
To 10 mL
Syringe
Foam core
board (not
included)