User's Manual

56
AC/DC Electronics Laboratory 012-05892A
®
Optional
➀ Use the voltage sensor in Analog Channel B to measure the peak voltage across each of the
components of the circuit individually. The sum of these peak voltages do not equal the applied
peak voltage. Why not? Draw a phasor diagram to explain this.
➁ Determine whether the resonant frequency depends on the resistance.
To see if the resistance makes a difference, set the Scope to the resonant frequency and then
replace the 10 Ω resistor by a 100 Ω resistor. Does the resonant frequency increase, decrease, or
stay the same?