User's Manual

35
012-05892A AC/DC Electronics Laboratory
®
PART II: Equipment Setup for Light Bulb Filament
➀ Remove the resistor from the component springs on the AC/DC Electronics Lab Board.
➁ Use two of the 10” wire leads to connect between the component springs near the banana jacks
and the component springs above and below 3 VOLT BULB “C”.
3 VOLTS MAX
C
W
3.3Ω
EM-8656
AC/DC ELECTRONICS LABORATORY
C
C
B
KIT NO.
PART III: Data Recording – Light Bulb Filament